|

30
inch Retractable Series "B" USB Cable
Series "B" USB
Connector for mating with our Model 2090 and the Model 2040
Circuit boards. A nice little gadget to have around. Eliminates the
"clutter" behind your Avionics Panel. Use only the amount of cable
you need. Store the rest.
$2.50 each

Plastic
Faceplate(NEW!)
Used to mount your Push Buttons, Toggle, Rocker Switches when
designing and wiring your own Panel. This Attractive Panel is
made of durable Black Plastic that measures 7.75 inches by 2.32
inches. The Panel is Textured on the front, with a flat finish on
its back. Just Drill the required hold size mount your Switches
or even the Push-Pull Cessna Slide Assemblies to build your own
Throttle Quadrant. Photo shows Slide Assemblies mounted to
Faceplate. All faceplates are NEW
without Holes.
SPECIAL SALE PRICE
$0.75each
With any $10.00
Purchase
Attractive Gray Plastic Cabinet (new)
 A Very
Attractive Plastic Cabinet used to mount your Push Buttons, Toggle,
Rocker Switches. This is the same cabinet we use on all of our
Avionics Panels (Model 1010, 1010 B, 1030/1040HiRES Throttle
Quadrant).
This Cabinet is made
of durable Gray Plastic that measures 7.9 inches by 6.3 inches by
2.5 inches. The Cabinet also comes with two Textured Faceplates for
the front and back.
$10.25 each
Rotary Potentiometer (Short Shaft)
This is a 100K ohm Rotary
Potentiometer with a Linear Taper output. This item is used
extensively with homemade Flight Simulator Panels.
The Pot can be easily
connected to our Rotary Encoder Board with just 3 wires. Design your
own Rudder Pedals or can be used on your instrument panel to perform
various functions. Combined with our Rotary Encoder, the
possibilities are Endless. Shaft
is .25 inches in Dia. & .5 inches in Length

100K Ohm Linear
Potentiometer (Short Shaft)
$1.25 each

Rotary Potentiometer (Long
Shaft)
This is a 100K ohm Rotary
Potentiometer with a Linear Taper output just as the pot seen above
except is has a 1.32 inch long 1/4in diameter shaft. Just perfect
for building your own Elevator Trim Wheel.
Easily connects to our Rotary Encoder Board.
100K Ohm Linear
Potentiometer (Long Shaft)
$1.75 each

36
inch Series "B" USB Cable
Standard USB Connector
for mating with our Model 2090, the Model 2040 & the Model 2097
Circuit boards. Series "A" connector on one end and a Series
"B" on the other.
$2.50 each

Elevator Trim Wheel for use with the
2097
An EASY add-on
for that REALISTIC Flight. Just like our 1060 Retro-fit this Trim
Wheel is terminated with a 3 Pin Male Connector. Just plug the
connector into the 2097 board. Designed for ease of installation,
calibration and above all; Easy to Use!
$28.75 each

|