Thank you for your purchase of our Cessna 2.0 Panel.
The Models 2790/95 are compatible with X-Plane (v10 and 11).

Below can be seen the Table that contains the Switch settings that need to be configured using your Flight Simulator software. It is assumed that a knowledge of SETTING the Flight Functions in X-Plane are already known, so the instructions on Basic programming will not be covered here.
So with that in mind, Happy Flying

Click here to join DesktopAviator
Click to join DesktopAviator
All Aviation Sites
GAC TOP 100 SITES - www.globalaircraft.org
DirectoryAviation
Links to aviation directory
resources & information websites

AVIATION TOP 100 - www.avitop.comAvitop.com
Avitop.com

Desktop Aviator HOME Page
Contact us
International Shipping Info
Programming the
Cessna  2.0  Panel
 
Before programming the switches, plug the Panel into an unused USB Port and allow your computer to automatically install the needed Driver Software. All DTA circuit boards and panels are designed as HID Joystick inputs, so as to make the boards and panels compatible with all Windows Operating Systems.

With the Panel's Driver software installed, you can now RUN your copy X-Plane (10.xx and up) and configure the switches as indicated below.
 
Programming the  Cessna Panel
Installation Instructions
Panel Key/Toggle Switch
But:adv Folders
X-Plane Assignment
Key Switch OFF magnetos Magnetos OFF
Key Switch RIGHT   Magnetos right for engine #1
Key Switch LEFT   Magnetos left for engine #1
Key Switch BOTH   Magnetos both for engine #1
Key Switch START starters Engage starter #1
MASTER ALT (up) electrical Generator #1 ON
MASTER ALT (dwn)   Generator #1 OFF
MASTER BATTERY (up)   Battery #1 ON
MASTER BATTERY (dwn)   Battery #1 OFF
FUEL PUMP (up) fuel Fuel Pump engine #1 ON
FUEL PUMP (dwn)   Fuel Pump engine #1 OFF
BCN (up) lights Beacon Lights ON
BCN (dwn)   Beacon Lights OFF
LAND (up)   Landing Lights ON
LAND (dwn)   Landing Lights OFF
TAXI (up)   Taxi Lights ON
TAXI (dwn)   Taxi Lights OFF
NAV (up)   Nav Lights ON
NAV (dwn)   Nav Lights OFF
STROBE (up)   Strobe Lights ON
STROBE (dwn)   Strobe Lights OFF
PITOT HEAT (up) ice Anti-ice LEFT pitot heat ON
PITOT HEAT (dwn)   Anti-ice LEFT pitot heat OFF
MASTER AVIONICS (up) systems Avionics ON
MASTER AVIONICS (dwn)   Avionics OFF

With the Panel now programmed for X-Plane Flight Functions, load and run one of the many aircraft available. Test all switches and key switch positions for the correct operation.

These switch configuration settings can be used for both the 2790 and the 2795 Cessna Panels. NOTE: Seeing that FSX/FSUIPC uses the TOGGLE  settings for most of their flight configurations, the 2790 and the 2795 panels are not compatible.
Happy Flying!

website counter